One address in — every trade measured at once. Roof squares, siding, gutters LF, fencing, concrete, pool, HVAC — an instant read in under 2 seconds — the complete CAD-verified property scope in about 24. Built for GCs who scale.
Ten verticals run on this engine one trade at a time. The GC tier runs them all at once — one address returns the numbers every sub on the job needs, from the same aerial + AI measurement core.
True squares with per-facet pitch, classified edge lengths, and a waste-adjusted order figure.
Wall square footage by side with windows and doors netted out — exteriors and painting scoped together.
Eave LF and downspout counts straight off the roof geometry.
Lot perimeter LF with gate allowances — fencing sub bid, done before the site walk.
Driveways, walkways and slab areas measured from the aerial.
Yard area, equipment access paths, and clearances for the pool crew.
Footprint, orientation, and ventilation math for equipment placement.
Lot area minus footprint — the outdoor scope your landscape sub prices from.
Every measurement vendor demos well. These are the two reasons GCs standardize on this engine — and never leave.
Flat, honest pricing on every pull. No volume punishment. No per-report ransom that scales up the moment your job count does. A GC running forty scopes a month pays the same fair rate per pull as the crew running four — the pricing that finally respects the general contractor.
130M+ building footprints. All 50 states. The same tool and the same pricing from your first county to your fiftieth. Open a new market Monday, pull scopes there Monday afternoon — no new vendor, no new contract, no coverage map surprises. Nobody outgrows us.
One pull produces the master homeowner proposal — every trade priced on one document — plus per-trade sub bid packages. Hand each sub their scope with the numbers already locked. No re-measuring, no "my tape says different," no scope drift between the bid and the build.
Measurement superpowers are half the package. The GC tier ships with the command center that runs the rest of the operation — your contracts, your network's KPIs, and your job load, blended into one screen.
Every master proposal and sub agreement in one place — generated from the measurement, tracked to signature.
Close rates, cycle times, and margin across your whole network of subs and crews — live, not month-end.
Every job, every stage, every crew's load on one board — see the bottleneck before it costs you a week.
Tom handles follow-ups, scheduling, and contact capture — the office work that eats your evenings runs itself.
Materials and pricing computed from the geometry, at flat honest rates — the same moat, wired into every bid.
The 130M-building, 50-state core under it all — every tool above feeds off the same 2-second read and 24-second CAD pull.
Straight off the engine from a single live pull — the flagship measurement report, the branded proposal, and the scope pack your subs bid from.
Type an address. Two seconds later you're holding the read — the CAD-verified whole-property scope lands in ~24, and the software pack runs everything after.
The Measure Center is the measurement-technology division of the 9 Figure Roofer national network — the same engine that powers every 9FR roof price, claim, and installer report.
