Condensers, package units, rooftop curbs and ventilation — placement is geometry. The engine measures the roof, the footprint and the clearances so your install plan starts before the ladder does.
One address in — the numbers a hvac bid actually runs on, out. All from the same aerial + AI measurement core.
Flat and low-slope facet areas with pitch data — see where a curb or package unit can actually sit.
Footprint-to-lot-line clearance math finds legal, serviceable condenser locations from the aerial.
Attic square footage with recommended intake and exhaust NFA — ridge vent and intake math straight off the report.
Building footprint and dimensions drive trunk-length and chase-planning estimates before the crawl.
Existing vents and penetrations counted and mapped — know the roof you're cutting into.
Footprint, wall areas and roof geometry — the load-calc inputs that usually take a site visit to gather.
The ventilation page from a live report — attic area with recommended exhaust and intake NFA computed. Airflow math, pre-done.
Type any US address — the engine finds the structure in a 130M+ building footprint database.
Aerial imagery is measured, classified and confidence-scored in the cloud. No ladder, no tape, no drive time.
Branded PDF + data payload with the hvac numbers on this page — ready to price and send.
Type an address. Twenty seconds later you're holding the numbers.
The Measure Center is the measurement-technology division of the 9 Figure Roofer national network — the same engine that powers every 9FR roof price, claim, and installer report.
